Ejector pins heater EJ - 1

EJ-1 is a gas heater in which the force applied to the internal hole studs hot mixture allows for quick heating, which ensures tightening of studs (M140, M120), approximately 20 minutes.
Before other similar heaters has significant advantages:
• Dimensions and weight of the heater greatly reduced: diam.120h150 size, weight 3.5 kg;
• Ejecting (discharge) increased by 3 times, thus significantly increase the consumption of gas mixtures;
• Structurally altered elements, limiting the life of the earlier reference design, thus improving the reliability of a new heater;
• Increased capacity of ejector heater and the development of the aerodynamics of motion in the gas mixture hairpin, where the bottom flange of the cylinder does not provide openings for the duct air / gas mixture, allowed to lift any restrictions on the running of these pins and allowed to delay them as effectively as those with cross-pin holes in the flange .
A detailed techno-commercial offer, you can get by sending an email mail@lenturbo.ru or fax (812) 531-20-20